The SnapPad Jack Stand Pads for Motorhome # SP34FR4 do in fact just snap on, so your assumption was correct. There is no definitive way to line up the pad other than get it at as close as you can (while staying safe); you are going to have to eyeball it. As for the number, it is best to do them one at a time, yes. view full answer...
For a hardwired 50 amp cord like what you have you'd have to insert the free end of the cable into the MorRyde part # MR47RR and reel it in that way. If you wanted to change your setup to a detachable cord you certainly could so that you could reel it up from the opposite end.
To do that you'd need to cut the attached cable and install the part # 381684 on one end and then on the other install the # F30ITRPSAM. view full answer...
The Curt Auxiliary LED Indicator Lights part # C53201 would indeed need to be hardwired into the trailer lighting circuits if using a 7-way trailer connector as there is no tee and adapter combo I am aware of for this. It should just be a power and ground wire. I suggest the running light circuit for power. view full answer...
The Curt Spectrum Trailer Brake Controller part # C51170 only draws a small amount of power while not in use. It would only be able to kill the battery from this draw after several months of inactivity. The reason it still draws power while not in use is to store any save settings. Therefore, if you were to install some sort of in-line switch to cut power you would have to go through the setup procedure each time power is restored. view full answer...
The Roadmaster Reflex Steering Stabilizer with Mounting Brackets for Class A Motor Homes # RM-RBK6-RSSA is not the correct fit for your 2018 Tiffin V-10 Motorhome. The # RM-RBK25-RSSA is the correct fit and will correct your fit issue so you will just need the Custom Mounting Brackets for Roadmaster Reflex Steering Stabilizer # RM-RBK25. view full answer...
The correct Roadmaster Reflex Steering Stabilizer with Mounting Brackets for a 2019 Ford F-53 Chassis is part # RM-RBK25-RSSA. In regards to installation, the Custom Mounting Brackets install on the driver side of the front axle. view full answer...
The SumoSprings Maxim Custom Helper Springs - Rear Axle # SSR-183-54-1 can be installed without removing the wheels on your 2014 Tiffin Allegro Open Road 36LA, but it will be more complicated because of restriction working room. I've attached a video to show you the installation which will require mounting the upper bracket to the frame which will require drilling a few holes.
It is possible to install without removing the wheel, but having the equipment for drilling holes in close proximity... view full answer...
Go To Results